Mop&Glow seems to be a very popular in-home product here on the Island, so it will be the focus of our first tip of the week!

• When should you use Mop&Glo?
• How often should it be applied?
• How to prepare and apply Mop&Glo to your floors.
• Common issues with Mop&Glo.
• How to remove Mop&Glo build-up. 

​

In my opinion, Mop&Glo is a mixed bag. When applied correctly to a properly prepared floor, the results can be stunning, leaving you with a satisfying protective shine to enjoy on those wonderful sunny days. However, we have noticed that there are a few common mistakes that are easy to make, though sometimes intensive to fix. The most common issues being either dirt and hair being trapped between the layers of dried product or the buildup and/or discoloration of floors due to extra solution or using on the wrong kind of floor. 


So, the first question:
​
When Should You Use Mop&Glo?

Mop&Glo is used predominantly for tile, vinyl, hardwood, marble, linoleum, ceramic and other no-wax floors. It's main purpose is to create a protective surface that not only shines, but helps prevent everyday dents and scratches from marring the flooring underneath. Most importantly, it is not recommended for unsealed/worn wood or unsealed ceramic surfaces. *If applied to these surfaces, it can leave spots, streaks, and/or discoloration that can be very difficult and sometimes impossible to remove. 


How Often Should Mop&Glo be Applied?

​This depends on your floor as well as the rate of foot traffic across the floor in question. If you have heavy foot traffic and want the shiniest floor you can have, apply Mop&Glo two times a month maximum. For low or regular foot traffic, I find that applying once a month is all you need, which saves you product and greatly reduces the amount of build-up that eventually accumulates around the edges of the floors. 

If you are nervous about using Mop&Glo on your hardwood floors or have already sworn it off due to a bad experience, watch the video below for an alternative way to keep your hardwood floors clean and shiny:

​How to prepare and apply your floors for Mop&Glo

Technically, you can mop your floor straight with Mop&Glo as long as you pick up any leftover particles during or right after mopping. However, I find it better to sweep/vacuum and mop very well beforehand, let the floor dry, then apply Mop&Glo, picking up any particles still left (they always seem to come from somewhere, huh?). My opinions aside, here are the official steps to applying Mop&Glo, according to manufacturers instructions:

"Before applying Mop & Glo, sweep or vacuum the floor.

1. Squeeze out a small amount of Mop & Glo directly onto floor. [I prefer an "S" shaped pattern]
2. Immediately use a damp mop, sponge, or rag to spread product evenly over a 3 x 4 ft area of the floor.
3. Rinse mop to remove dirt, move to the next area of the floor and repeat the process.

Your floor will dry normally to a beautiful, long lasting shine in 10-20 minutes. After floor is dry, apply additional coats if a higher gloss is desired."


Common Issues with Mop&Glo

The most common issues I see after people have used Mop&Glo are dirt or hair stuck in the layers of dried applications and a grayish buildup around the edges of the floor, near the baseboards. Other common complaints are sticky areas, discoloration, or a dull/milky appearance after drying. 

Trapped dirt and hair often arise from not cleaning the floor well enough before applications or unexpected foot traffic before drying. The discolorations and sticky buildup usually occur if the floor was unsealed/worn wood, unsealed ceramic or porcelain tile, or after many applications of the product. 

Sometimes wood and tile floors come out milky, hazy, or streaky. I believe this is most often caused by over-applying, or using on previously oiled or waxed floors. Since Mop&Glo is acrylic based, it may not mix well with previously applied waxes and oils. 


How to remove Mop&Glo from your floors.  

Applying Mop&Glo can be easy and produce satisfying results, but when things do go wrong, it can be a pain to remove.

According to the manufacturers, "If your floor shows signs of build-up or discoloration, regularly remove the older layers of polish with the following process: 

Mix 1/4 cup all purpose cleaner (non bleach containing), and add 1 cup ammonia in 1/2 gallon of warm water and spread over floor. (Do not mix bleach based products with ammonia, test in an inconspicuous area first.) If your sealed hardwood floor shows signs of build up, remove the older layers of polish with a commercial floor stripper product suitable for your flooring..."

Other methods people have reported to work for them *use at your own risk:

• ​With a fresh mop, put ammonia full strength or in a strong solution onto the floor and let stand for 10-15 minutes, mop up and squeeze out often. Rinse with water after all ammonia is mopped up. 
• Spray or pour non-acetone nail polish remover on tile floor, spread around with mop, and then rinse off with water. 
• Spray or pour straight vinegar onto floor, let sit for 10 minutes, scrub floor, mop up with clean water. This may take two or more times to remove all layers of build-up. 

So, it's gotta be asked:

• Why would anyone decided to start a cleaning business?
• Isn't it hard enough to manage one's own house and it's cleaning needs?
• Can cleaning actually be a fulfilling line of work? 
• Isn't it a lot of work for little pay?

Well, yes and no. 

Yes, it can be hard to juggle a family and keep your own house in order while cleaning other people's places. After a day (or several days) of particularly hard work, who wants to come home and clean house? I have to admit, there are days that I just ignore it all and save energy for my clients. And that is okay! It's my choice, and that is the beauty of it!

On the flip side, I find it rather rewarding to go into a building and leave it better than I found it, especially when the client is unable to do it themselves. Despite the energy expended during a job, I find a certain satisfaction in seeing everything put back to order and knowing that my honest, hard work will help others live healthier and happier lives in their home and work spaces. 

As for the pay, while cleaning does not create a fortune (for most cleaning businesses at least), it is enough for our family to pay the bills, put food on the table, and even squirrel a little money into savings, which is why we work, right? I feel cleaning is often taken for granted, but that it is a service that people will always need (like nursing, food production, or construction) and therefore offers a basic level of job security, if you are willing to work for it. 

So, here comes the most important question: Why start a professional cleaning business? 

The answer to this question is different for everyone, however, the biggest driving factor for us was to spend more time together as a family. We felt that the regular 9am-5pm work week prevented us from having the family-time we craved. With a toddler added to the mix, we found it was quite stressful for one of us to be gone all day and sometimes not even see our little-one due to sleep schedules, much less have the energy to play or fully interact if he was awake. This coupled with an unsustainable living situation and the need to move to Hollis, AK, we had the perfect storm for change. 

So after some brainstorming, we did the unthinkable. We both quit the jobs that were keeping our family apart, moved to Hollis, and used our skills to create an opportunity to work as a family: Southeast Clean & Care! 

Sure, there are some days we look back and wondered if we made the right decision, but we have never been stronger as a family, than after we started working for ourselves. There is a certain satisfaction in not only being with my family all day, but also creating the ability for ourselves to decide our own schedules and to be fully responsible for our own income.  

This is the first post for the Southeast Clean & Care blog, so stay tuned for more tips, tricks, and insights into general cleaning and running your own cleaning business!